Resultat 1 till 3 av 3
  1. #1

    Reg.datum
    jul 2007
    Namn
    Jimmie Karlsson
    Ort
    Perstorp
    Inlägg
    102

    Byte handbromswire

    Nu är det dags att byta båda handbromswirarna på min Golf IV eftersom en av dom är helt kass.
    Detta moment har jag aldrig tidigare utfört men jag har hittat en liten guide på VWvortex & saxar här in en del av själva justeringen.

    PART III - ADJUSTMENT

    The proper adjustment of the e-brake is critical so that the rear brakes are quickly engaged before the full motion of e-brake handle is exhausted but with the rear wheels being allowed to spin freely with the e-brake disengaged. The Bentley manual states that the e-brake is properly adjusted when both rear wheels are difficult to turn with the handle raised up four notches and rotate freely with the handle all the way down. I prefer the handle to be a little firmer/tighter than this, and have it adjusted so that the rear wheels are difficult to turn at the second notch. You may use the second, third or fourth notch depending on what feel you prefer and as long as the above two conditions are met.

    To adjust the e-brake handle, perform the following steps:

    19. Lower the e-brake handle completely.

    20. Firmly depress the brake pedal once.

    21. Raise the handle to the fourth notch (or whatever one you prefer).

    22. Tighten (or loosen) the compensator nut until both rear wheels become difficult to turn.

    23. Lower the handle completely and make sure that both rear wheels spin freely. If one or more doesn't, loosen the compensator nut a little at a time until both wheels spin freely.

    The e-brake mechanism should now be properly adjusted.

    Är detta en bra guide att förlita sig på för själva justerings biten & har ni några punkter som ni skulle vilja lägga till för att få handbromsen perfekt?

  2. #2

    Reg.datum
    jul 2007
    Namn
    Jimmie Karlsson
    Ort
    Perstorp
    Inlägg
    102
    Upp!

    Någon?

  3. #3

    Reg.datum
    maj 2007
    Namn
    Magnus Gulldén
    Ort
    Rydaholm
    Inlägg
    689
    Är inte säkert att du behöver justera något.
    Och köp vajer hos vw, verkar vara sämre tätningar på andra.
    Har varit med om det 2 gånger, bytt och sen 1-2år senare fått byta igen då den kärvat igen.
    När du bytt vajer ska du kolla hur långt handbroms armen på oket ligger från stoppet.
    Ca 1-2 mm har jag för mig det ska vara.
    Annars ska det inte vara något speciellt.

Liknande ämnen

  1. Hjullager byte
    Av magnusT i forum VW-forum
    Svar: 1
    Senaste inlägg: 2012-10-09, 14:13
  2. Handbromswire Golf II -88
    Av binke i forum VW-forum
    Svar: 0
    Senaste inlägg: 2010-03-09, 14:54
  3. Handbromswire Golf 4.
    Av nill0w i forum VW-forum
    Svar: 12
    Senaste inlägg: 2010-01-13, 10:21
  4. Byte av handbromswire Passat -99
    Av Draedon i forum VW-forum
    Svar: 1
    Senaste inlägg: 2009-07-21, 13:43
  5. Byte framhjulslager
    Av dieselrules i forum VW-forum
    Svar: 1
    Senaste inlägg: 2008-01-04, 09:24

Behörigheter för att posta

  • Du får inte posta nya ämnen
  • Du får inte posta svar
  • Du får inte posta bifogade filer
  • Du får inte redigera dina inlägg
  •  
© 2018 Volkswagen Club Sweden | Kontakta oss | Om cookies | Skapad av Per Lundin